- Home
- Millwork
- Custom millwork
- Richmond Hill
Custom millwork in Richmond Hill
Custom millwork is anything built for a specific room that a catalogue cannot supply: built-ins, panelling, feature walls, concealed doors. Richmond Hill mixes postwar houses with closed kitchens and bulkheads around Yonge and Bayview with newer subdivision and infill houses open to a great room. Century houses ask for panelling that follows existing trim and scribes to plaster; newer houses ask for feature walls and built-ins that give a plain room a centre.
Richmond Hill, on the ground.
Most houses take a driveway delivery and a level entry, and attached garages give the crew somewhere dry to stage boxes. Panels and boxes are cut and finished in the shop, dry-fitted, then delivered and scribed to your walls and ceilings on site.
Wall units and offices in Richmond Hill are fitted joinery, so outlet and data positions are recorded at the measure and the back panels are cut for them in the shop.
Read more about custom cabinetry in Richmond Hill or the full custom millwork page.
On the drawings, and on the quote.
- 01A measured survey and a set of elevations for every piece
- 02A photorealistic rendering of the millwork in your room, with your finish
- 03Panels, doors and boxes cut, edged and finished in our shop
- 04Sequence-matched veneer or sprayed paint from the same deck as your kitchen
- 05Lighting wired in the shop and concealed fixings drawn in advance
- 06Delivery, scribing to walls and ceilings, and install by our crew
No figures published. The drivers, in order.
| Driver | What we look at |
|---|---|
| Square footage of finished face | Millwork is priced by the finished surface and the number of parts behind it. |
| Material and finish | Painted MDF panels sit at one end; sequence-matched walnut and solid fluting at the other. |
| Site conditions | Out-of-square walls, sloped ceilings and bulkheads add scribing and site time. |
| Hidden function | Concealed doors, lighting, drawers behind panels and stone all add parts and trades. |
The number comes from the drawings, line by line. Colour and hardware are the smallest lines on a millwork quote.
Asked before the first call.
Do you take small millwork jobs in Richmond Hill?
Yes. A single built-in, a window seat or one panelled wall in Richmond Hill goes through the same measure, drawing and shop build as a whole kitchen.
Can millwork in Richmond Hill match my kitchen finish?
Yes. If we built the kitchen the finish comes from the same deck and veneer lot. If someone else did, bring a door and we match the colour or species from a sample.
Can you build a wall unit around a mounted television and hide the wires?
Yes. We need the screen size, the bracket type and the position of the outlets and data points, all taken at the measure. Back panels are cut in the shop for the cable runs, and a service gap is left behind the screen so a future bracket change does not mean pulling the unit apart.
There is a bulkhead over the sink in our older Richmond Hill kitchen. Can it come out?
Sometimes. It depends on what is inside: a duct or a plumbing stack can often be rerouted, structure cannot. We open the question at the measure and design for both outcomes, so the cabinetry works whether the bulkhead stays or your contractor removes it before we deliver.