- Home
- Millwork
- Custom millwork
- Pickering
Custom millwork in Pickering
Custom millwork is anything built for a specific room that a catalogue cannot supply: built-ins, panelling, feature walls, concealed doors. Kitchen replacements, islands, basement bars and media walls are the bulk of what we build in Pickering.
Pickering, on the ground.
Pickering is largely 1990s and 2000s subdivision housing, with older stock near the lake and country properties to the north. Century houses ask for panelling that follows existing trim and scribes to plaster; newer houses ask for feature walls and built-ins that give a plain room a centre. Attached garages and wide driveways make delivery straightforward in the subdivisions, while rural addresses need the route confirmed first. Panels and boxes are cut and finished in the shop, dry-fitted, then delivered and scribed to your walls and ceilings on site.
Finished basements in Pickering lose height to duct bulkheads, so we measure after framing rather than working from the joists.
Read more about custom cabinetry in Pickering or the full custom millwork page.
On the drawings, and on the quote.
- 01A measured survey and a set of elevations for every piece
- 02A photorealistic rendering of the millwork in your room, with your finish
- 03Panels, doors and boxes cut, edged and finished in our shop
- 04Sequence-matched veneer or sprayed paint from the same deck as your kitchen
- 05Lighting wired in the shop and concealed fixings drawn in advance
- 06Delivery, scribing to walls and ceilings, and install by our crew
No figures published. The drivers, in order.
| Driver | What we look at |
|---|---|
| Square footage of finished face | Millwork is priced by the finished surface and the number of parts behind it. |
| Material and finish | Painted MDF panels sit at one end; sequence-matched walnut and solid fluting at the other. |
| Site conditions | Out-of-square walls, sloped ceilings and bulkheads add scribing and site time. |
| Hidden function | Concealed doors, lighting, drawers behind panels and stone all add parts and trades. |
The number comes from the drawings, line by line. Colour and hardware are the smallest lines on a millwork quote.
Asked before the first call.
Do you take small millwork jobs in Pickering?
Yes. A single built-in, a window seat or one panelled wall in Pickering goes through the same measure, drawing and shop build as a whole kitchen.
Can millwork in Pickering match my kitchen finish?
Yes. If we built the kitchen the finish comes from the same deck and veneer lot. If someone else did, bring a door and we match the colour or species from a sample.
Can you get rid of the corner cabinet in our 1990s kitchen?
Usually yes. The fix is often to end the run before the corner, panel the return and put that storage into deep drawers elsewhere. Where the corner has to stay, a pull-out beats a lazy susan for reach and for what you can actually see. We show both options on the elevations.
Our basement ceiling is low after the ducts. Will a bar fit?
Yes, with the heights adjusted. We measure the finished ceiling at the lowest bulkhead and set any upper cabinet or glass rack under it, then keep the counter at a standard working height so it still feels normal to stand at. Everything overhead is drawn on the rendering so you can judge the headroom.