Vanities in York (Toronto)
York runs from Junction semis to Weston and Mount Dennis detached houses, mostly early last century, with plaster walls and narrow rooms. Older bathrooms tend to be narrow with the rough-in already fixed, while newer builds offer a wider wall and room for a double bowl. A custom vanity is built to the width you have and drawn around the plumbing, floating on wall blocking or standing as a furniture piece.
York (Toronto), on the ground.
Main kitchens, basement second kitchens, vanities and closets make up most of the work here. We measure the rough-in and the wall, build and finish the vanity in our shop, then set and level it on site so the stone can be templated against the real cabinet.
Older houses in York have moved since they were built, so scribe stiles and site-cut fillers are part of the design from the first drawing.
Read more about custom cabinetry in York (Toronto) or the full vanities page.
On the drawings, and on the quote.
- 01Elevations and a photorealistic rendering, with the sink and tap shown in place
- 02Drawer boxes notched around the trap so the drawer still opens fully
- 03Soft-close hinges and runners throughout
- 04Integrated pulls machined into the door, or hardware you choose
- 05A finished underside on a floating vanity, or a plinth and legs on a furniture piece
- 06Templating for the stone top once the boxes are set and level
No figures published. The drivers, in order.
| Driver | What we look at |
|---|---|
| Floating or furniture style | A floating vanity needs blocking in the wall and a finished underside; a furniture-style piece adds legs and a plinth. |
| Sink and tap choice | An undermount bowl, a vessel or a moulded top each change the cabinet, and a wall-mounted tap moves the plumbing before the boxes are built. |
| Drawers around the plumbing | Notched drawer boxes take shop time that a door and a fixed shelf do not. |
| Finish and door detail | A slab door in paint is quicker than fluting, a mitred rail or a machined integrated pull. |
The quote is written line by line off the drawings, with the cabinet, the hardware and the stone shown separately so you can see where the money sits.
Asked before the first call.
Can you replace a vanity without retiling the York bathroom?
Usually yes, if the new cabinet covers the same footprint or more. We measure the tile edges and the existing plinth line at step 01 and size the piece so no bare floor or unfinished tile is left showing.
How long is a bathroom out of use?
Only for the install and the stone. The cabinet goes in and is levelled in [n] days, the fabricator templates afterwards, and the top is fitted on their return. Your plumber reconnects once the stone is in.
Will a finished cabinet fit up my narrow staircase?
We check that at the site measure. We take the stair width, the headroom over the flight and the landing turn, then split the run into boxes that make it. If a section cannot go up assembled, it is built to be joined on the landing, with the joint placed where a stile falls so it does not show.
Can you build a second kitchen in the basement?
Yes. We design to the ceiling height under the lowest duct, use the sink and vent positions already there where we can, and keep the tall units clear of the beam. Any [second suite requirements from the City] are for the owner or the builder to confirm before the cabinetry is ordered.